Mazda 2: Accessory Sockets
Only use genuine Mazda accessories or
the equivalent requiring no greater than
120 W (DC 12 V, 10 A).
The ignition must be switched to ACC or
ON.
Type A

Type B

CAUTION
To prevent accessory socket damage
or electrical failure, pay attention to
the following:
- Do not use accessories that require
more than 120 W (DC 12 V, 10 A).
- Do not use accessories that are not
genuine Mazda accessories or the
equivalent.
- Close the cover when the
accessory socket is not in use to
prevent foreign objects and liquids
from getting into the accessory
socket.
- Correctly insert the plug into the
accessory socket.
- Do not insert the cigarette lighter
into the accessory socket.
Noise may occur on the audio
playback depending on the device
connected to the accessory socket
Depending on the device connected
to the accessory socket, the vehicle's
electrical system may be affected,
which could cause the warning
light to illuminate. Disconnect the
connected device and make sure
that the problem is resolved. If the
problem is resolved, disconnect the
device from the socket and switch
the ignition off. If the problem is not
resolved, consult an expert repairer,
we recommend an Authorised Mazda
Repairer.
NOTE
To prevent discharging of the battery, do
not use the socket for long periods with
the engine off or idling.
READ NEXT:
WARNING
Never use a cup holder to hold hot
liquids while the vehicle is moving:
Using a cup holder to hold hot
liquids while the vehicle is moving is
dangerous. If the contents spill, you
could
Bottle holders are on the inside of the front
doors.
CAUTION
Do not use the bottle holders for
containers without caps. The contents
may spill when the door is opened or
closed.
WARNING
Keep storage boxes closed when
driving:
Driving with the storage boxes open is
dangerous. To reduce the possibility of
injury in an accident or a sudden stop,
keep the storage boxes clos
SEE MORE:
REAR SUSPENSION LOCATION INDEX
Rear shock absorber
(See REAR SHOCK ABSORBER REMOVAL/INSTALLATION.)
(See REAR SHOCK ABSORBER INSPECTION.)
(See REAR SHOCK ABSORBER DISPOSAL.)
Rear coil spring
(See REAR COIL SPRING REMOVAL/INSTALLATION.)
Torsion beam axle
(See TORSION BEAM AXLE R
STARTING SYSTEM LOCATION INDEX
Starter interlock switch (MTX)
(See STARTER INTERLOCK SWITCH INSPECTION)
Starter
(See STARTER REMOVAL/INSTALLATION)
(See STARTER INSPECTION)
(See STARTER DISASSEMBLY/ASSEMBLY)
STARTER REMOVAL/INSTALLATION
WARNING:
Remove and install all parts whe
© 2016-2023 Copyright www.ma2auto.com
