Mazda 2: Cell Phones
Cell Phones Warning
WARNING
Please comply with the legal regulations concerning the use of communication equipment in vehicles in your country: Use of any electrical devices such as cell phones, computers, portable radios, vehicle navigation or other devices by the driver while the vehicle is moving is dangerous.
Dialing a number on a cell phone while driving also ties-up the driver's hands. Use of these devices will cause the driver to be distracted and could lead to a serious accident.
If a passenger is unable to use the device, pull off the right-of-way to a safe area before use. If use of a cell phone is necessary despite this warning, use a hands-free system to at least leave the hands free to drive the vehicle. Never use a cell phone or other electrical devices while the vehicle is moving and, instead, concentrate on the full-time job of driving.
READ NEXT:
Recording of Vehicle Data
This vehicle is equipped with a computer which records the following main
vehicle data
related to vehicle controls, operation, and other driving conditions.
Recorded data
Vehicle conditions su
Declaration of Conformity
Keyless Entry System/Immobilizer System
Blind Spot Monitoring (BSM) System
Bluetooth ® Hands-Free
Type A/Type B
Type C/Type D
Electromagnetic Compatibility
Your Mazda has been tested and certifi ed to the UNECE *1 10 regulation as
related to
electromagnetic compatibility. Radio Frequency (RF) transmitter equipment (e.g.
cellular
telephones, amateur
SEE MORE:
Emergency Operation for Starting the Engine
If the KEY warning light (red) illuminates,
or the push button start indicator light
(amber) fl ashes, this could indicate that
the engine may not start using the usual
starting method. Have your vehicle
inspected at an expert repairer, we
recommend an Authorised Mazda Repairer
as soon as pos
Manifold Absolute Pressure (MAP) Sensor
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the fresh-air duct and the air cleaner as a single unit. (See
INTAKE-AIR SYSTEM REMOVAL/INSTALLATION).
3. Disconnect the MAP sensor connector.
4. Remove the MAP sensor
5. Install in
