Mazda 2: DTC B0010:11/B0010:12/B0010:13/B0010:19/B0010:1A
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- Resistance other than 1.54-5.06 ohms detected in passenger-side air bag
module
(inflator No.1) circuit
- Wiring harness between passenger-side air bag module (inflator No.1) and
SAS control
module has malfunction
Possible Causes
- Passenger-side air bag module (inflator No.1) connector malfunction
- Open or short circuit the wiring harness between the passenger-side air
bag module (inflator No.1) and the SAS control module
- Passenger-side air bag module malfunction
- SAS control module malfunction
System Wiring Diagram

Diagnostic Procedure




READ NEXT:
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
inspection according to only th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
SEE MORE:
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
p
TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR INSPECTION
CAUTION:
Water or foreign objects entering the connector can cause a poor
connection or
corrosion. Be sure not to drop water or foreign objects on the connector
when
disconnecting it.
On-Vehicle Inspection
1. Disconnect the coupler compone
© 2016-2023 Copyright www.ma2auto.com
