Mazda 2: DTC B0011:11/B0011:12/B0011:13/B0011:19/B0011:1A
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- Abnormal resistance (other than 1.54-5.06 ohms) detected in the
passenger-side air
bag module (inflator No.2) circuit
- Wiring harness between passenger-side air bag module (inflator No.2) and
SAS control
module has malfunction
Possible Causes
- Passenger-side air bag module (inflator No.2) connector malfunction
- Open or short circuit or short to ground or short to power supply in the
wiring harness between the passenger-side air bag module (inflator No.2) and
SAS control module
- Passenger-side air bag module (inflator No.2) malfunction
- SAS control module malfunction
System Wiring Diagram

Diagnostic Procedure




READ NEXT:
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
inspection according to only th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
SEE MORE:
CANISTER VENT (CV) SOLENOID VALVE REMOVAL/INSTALLATION
1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION).
2. Remove in the order indicated in the table.
CV solenoid valve connector
Evaporative hose
Evaporative hose
CV solenoid valve
3. Install in the reverse order
FOREWORD
Outline
The OBD (on-board diagnostic) system has the following functions:
Malfunction detection function: Detects malfunctions in the air bag
system and outputs DTCs.
PID/data monitor function: Reads out specific input/output signals and
the system status.
Diagnostic DTCs can
© 2016-2023 Copyright www.ma2auto.com
