Mazda 2: DTC B0094:11/B0094:13/B0094:87/B0094:96
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- Malfunction in the wiring harness between the crash zone sensor and SAS
control
module
- Malfunction in the crash zone sensor circuit
Possible Causes
- Crash zone sensor connector malfunction
- Open or short circuit or short to ground or short to power supply in the
wiring harness
between the crash zone sensor and SAS control module
- Crash zone sensor malfunction
- SAS control module malfunction
System Wiring Diagram

Diagnostic Procedure



DTC B0094:55
System Malfunction Location
- Configuration setting error (crash zone sensor structural malfunction)
Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- SAS control module configuration setting has not been done correctly
Possible Causes
- SAS control module configuration setting not implemented
- SAS control module configuration setting invalid
- The crash zone sensor is installed incorrectly or the incorrect sensor
is installed.
- SAS control module malfunction
Diagnostic Procedure


READ NEXT:
System Malfunction Location
Seat weight sensor collision detection
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Perf
System Malfunction Location
Seat weight sensor control module circuit open to power supply
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
perform
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
inspection according to only th
SEE MORE:
WARNING:
When performing a road test, be aware of other vehicles, people,
impediments, etc. to avoid an accident.
NOTE:
When the legal speed limit must be exceeded, use a chassis dynamometer.
Road Test Preparation
1. Inspect the engine coolant. (See ENGINE COOLANT LEVEL INSPECTION).
2. Insp
CONTROL SYSTEM LOCATION INDEX
BCM (body control module)
BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION
CAUTION:
When replacing the BCM, the configuration procedure must be performed
before removing the BCM. Replacing the
BCM without performing the configuration procedure will result in sys
© 2016-2023 Copyright www.ma2auto.com
