Mazda 2: DTC B00A0:07
System Malfunction Location
- Seat weight sensor collision detection
Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- The pressure from the seat weight sensor is not within specification
Possible Causes
- Seat weight sensor calibration setting not implemented
- Seat weight sensor calibration setting invalid
- Seat weight sensor deformation or malfunction
- Foreign object under seat causing load on or deformation of the seat
belt rail
- Front passenger-side seat under-bracket or frame deformed
- Weight acting on front passenger-side seat during calibration
- Front passenger-side seat part improperly installed at time of
calibration
- Floor deformed where front passenger-side seat attached
- Seat weight sensor control module malfunction
- SAS control module malfunction
Diagnostic Procedure



DTC B00A0:09
System Malfunction Location
- Seat weight sensor control module internal malfunction
Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- Seat weight sensor control module internal malfunction
Possible Causes
- Seat weight sensor control module malfunction
- SAS control module malfunction
Diagnostic Procedure


READ NEXT:
System Malfunction Location
Seat weight sensor control module circuit open to power supply
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
perform
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
inspection according to only th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
SEE MORE:
REAR AXLE LOCATION INDEX
Rear axle component
REAR AXLE INSPECTION
Wheel Bearing Play Inspection
1. Inspect the wheel bearing play in the same way as the front axle. (See
WHEEL HUB,
STEERING KNUCKLE INSPECTION).
If it exceeds the specification, replace the wheel hub component. (See
WHEEL HUB
REFRIGERANT PRESSURE SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Collect the refrigerant. (See REFRIGERANT CHARGING).
3. Remove the ground from the engine mount No.3.
4. Remove the air cleaner installation bolt and slide the air cleaner
component aside.
5. Disconnec
© 2016-2023 Copyright www.ma2auto.com
