Mazda 2: Saving Fuel and Protection of the Environment
How you operate your Mazda determines
how far it will travel on a tank of fuel. Use
these suggestions to help save fuel and
reduce CO2.
- Avoid long warm-ups. Once the engine
runs smoothly, begin driving.
- Avoid fast starts
- Drive at lower speeds.
- Anticipate when to apply the brakes
(avoid sudden braking).
- Follow the maintenance schedule
(page 6-3 ) and have an expert repairer,
we recommend an Authorised Mazda
Repairer perform inspections and
servicing.
- Use the air conditioner only when
necessary.
- Slow down on rough roads.
- Keep the tyres properly infl ated.
- Do not carry unnecessary weight.
- Do not rest your foot on the brake pedal
while driving.
- Keep the wheels in correct alignment.
- Keep windows closed at high speeds
- Slow down when driving in crosswinds
and headwinds.
WARNING
Never stop the engine when going
down a hill:
Stopping the engine when going
down a hill is dangerous. This causes
the loss of power steering and power
brake control, and may cause damage
to the drivetrain. Any loss of steering
or braking control could cause an
accident.
READ NEXT:
WARNING
Be extremely careful if it is necessary
to downshift on slippery surfaces:
Downshifting into lower gear while
driving on slippery surfaces is
dangerous. The sudden change in tyre
speed c
WARNING
Make sure the fl oor mats are secured
with the grommets or the retainers to
prevent them from bunching up under
the foot pedals (Driver's side):
Using a fl oor mat that is not secured is
WARNING
Do not spin the wheels at high speed,
and do not allow anyone to stand
behind a wheel when pushing the
vehicle:
When the vehicle is stuck, spinning
the wheels at high speed is dangerous.
SEE MORE:
The Blind Spot Monitoring (BSM) system is designed to assist the driver in
checking the
area to the rear of the vehicle on both sides during lane changes by alerting
the driver to the
presence of vehicles approaching from the rear in an adjacent lane.
The Blind Spot Monitoring (BSM) system
KEYLESS RECEIVER REMOVAL/INSTALLATION [KEYLESS ENTRY SYSTEM]
1. Disconnect the negative battery cable.
2. Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION).
3. Remove in the order indicated in the table.
Connector
Nut
Keyless receiver
4. Install in the reverse order
© 2016-2023 Copyright www.ma2auto.com
