Mazda 2: Theft-Deterrent System

If the theft deterrent system detects an inappropriate entry into the vehicle or the intrusion sensor detects movement in the vehicle which could result in the vehicle (with the intrusion sensor) or its contents being stolen, the alarm alerts the surrounding area of an abnormality by sounding the siren/horn and fl ashing the hazard warning lights.

The system will not function unless it's properly armed. So when you leave the vehicle, follow the arming procedure correctly.

Intrusion sensor *

The intrusion sensor uses ultrasonic waves to detect movement inside the vehicle and to raise an alert of an intrusion into the vehicle.

The intrusion sensor detects certain kinds of movement inside the vehicle, however, it may also respond to phenomenon outside the vehicle such as vibrations, loud noise, wind, and air currents.

CAUTION

In order for the intrusion sensor to operate appropriately, be aware of the following:

• Do not hang clothing or objects from a head restraint or a coat hook.
• Return the extension sunvisors to their original positions.
• Do not blind the intrusion sensor by covering it or placing objects over it.
• Do not allow the intrusion sensor to get soiled or wipe it with a liquid.
• Do not shock or cause an impact to the intrusion sensor or the intrusion sensor bezel.
• Do not install seats or seat covers that are not Mazda genuine products.
• To prevent obstruction of intrusion sensor, do not place objects or cargo near the intrusion sensor that are higher than the head restraints.

Operation

Siren triggering conditions

The siren/horn sounds intermittently and the hazard warning lights fl ash for about 30 seconds when the system is triggered by any one of the following:

• Unlocking a door with an inside doorlock knob.
• Forcing open a door, the bonnet or the liftgate/boot lid.
• Opening the bonnet by operating the bonnet release handle.
• Switching the ignition ON without using the push button start.
• (With the intrusion sensor)  The intrusion sensor detects a movement in the vehicle.

The system will be triggered again (up to 10 times) if one of the above conditions remains.

• (With the intrusion sensor)

Disconnecting the battery terminal (the hazard warning lights do not fl ash).

The system will be triggered about 10 times.

NOTE

• The liftgate/boot lid does not open while the theft-deterrent system is operating.
• If the battery goes dead while the theft-deterrent system is armed, the siren will activate and the hazard warning lights will fl ash when the battery is charged or replaced.

How to Arm the System

1. Close the windows securely.

NOTE

(With the intrusion sensor) Even with a window open, the system can be armed, however, leaving the windows even partially open can invite theft, and wind blowing into the vehicle could trigger the alarm.

Refer to Cancelling the Intrusion/Tilt Sensor on page 3-46 .

2. Switch the ignition OFF.
3. Make sure the bonnet, the doors, and the liftgate/boot lid are closed.
4. Press the lock button on the transmitter or lock the driver's door from the outside with the auxiliary key.

   The hazard warning lights will fl ash once.

   (With the advanced keyless function) Press a request switch.

The security indicator light in the instrument panel fl ashes twice per second for 20 seconds.

5. After 20 seconds, the system is fully armed.

NOTE

The theft deterrent system can also be armed by activating the auto relock function with all the doors, the liftgate/boot lid and the bonnet closed.

Refer to Transmitter on page 3-4 .

 The system will disarm if one of the following operations takes place within 20 seconds after pressing the lock button:

•  Unlocking any door.
• Opening any door.
• Opening the bonnet.
•  Switching the ignition on.
• (With the advanced keyless function)

Pressing the electric liftgate/boot lid opener while the key is being carried.

To rearm the system, do the arming procedure again.

When the doors are locked by pressing the lock button on the transmitter or using the auxiliary key while the theft-deterrent system is armed, the hazard warning lights will fl ash once to indicate that the system is armed.

Cancelling the Intrusion Sensor (With Intrusion Sensor)

If the theft deterrent system has been armed while any of the following conditions are present, cancel the intrusion sensor to prevent the alarm from triggering unnecessarily.

(Intrusion sensor)

• Leaving the vehicle with a movable object, passengers or pets remaining inside.
• Leaving an object inside the vehicle that can roll around, such as when the vehicle is placed on a tilting, unstable surface when being shipped.
• Hanging small objects/accessories in the vehicle, hanging clothing on a coat hook, or placing other items which can move easily inside the vehicle.
• Parking in an area where there is strong vibration or loud noise.
• When using a high pressure or automatic car wash.
• Continuous shock and vibration from hail or thunder and lightning is transmitted to the vehicle.
• Doors are locked with a window left open.
• An accessory heater or device that produces moving air and vibration operates while the theft deterrent system is armed.

NOTE

If any door or the liftgate/boot lid remains closed for 30 seconds, all the doors and the liftgate/boot lid automatically re-lock and the theft deterrent system arms even if a window is left open.

To cancel the intrusion sensor, press the intrusion sensor cancel button on the transmitter within 20 seconds after pressing the lock button.

The hazard warning lights will fl ash three times.

NOTE

• To reactivate the intrusion sensor, turn off the armed theft-deterrent system and then rearm it.
• The intrusion sensor is operational when the theft-deterrent system is armed. To cancel the intrusion sensor, press the intrusion sensor cancel button each time the theftdeterrent system is armed.

To Turn Off an Armed System

An armed system can be turned off using any one of the following methods:

•   Pressing the unlock button on the transmitter.
• Starting the engine with the push button start.
• (With the advanced keyless function)

Pressing a request switch on the doors.

The hazard warning lights will fl ash twice.

NOTE

When the doors are unlocked by pressing the unlock button on the transmitter while the theft-deterrent system is turned off, the hazard warning lights will fl ash twice to indicate that the system is turned off.

To Stop the Alarm

A triggered alarm can be turned off using any one of the following methods:

• Pressing the unlock button or the boot button (saloon) on the transmitter.
• Starting the engine with the push button start.
•  (With the advanced keyless function)

Pressing a request switch on the doors.

Pressing the electric liftgate/boot lid opener while the key is being carried.

The hazard warning lights will fl ash twice.

Theft-Deterrent Labels

A label indicating that your vehicle is equipped with a Theft-Deterrent System is in the glove compartment.

Mazda recommends that you affi x it to the lower rear corner of a front door window.

READ NEXT: