Mazda 2: When Liftgate/Boot Lid Cannot be Opened

Mazda2 DJ 2014–2023 Owners Manual / If Trouble Arises / When Liftgate/Boot Lid Cannot be Opened

If the vehicle battery is dead or there is a malfunction in the electrical system and the liftgate/boot lid can not be opened, perform the following procedure as an emergency measure to Open it:

(Hatchback)

CAUTION

When Liftgate/Boot Lid Cannot be Opened


  1. Fold down the rear seatbacks.

    Refer to Split/One-piece Folding the Seatback on page 2-7 .

  2. Pull the centre section of the plastic fastener and remove the fasteners, then remove cover on the interior surface of the liftgate.

When Liftgate/Boot Lid Cannot be Opened


  1. Using a fl athead screwdriver, open the inner cover.

When Liftgate/Boot Lid Cannot be Opened


  1. Using a fl athead screwdriver, turn the lever to the right to unlock the liftgate.

When Liftgate/Boot Lid Cannot be Opened


(Saloon)

  1. Open the cover.
  2. Move the lever to the left to fold the seatback.

When Liftgate/Boot Lid Cannot be Opened


  1. Move the lever to the left to open the boot lid.

When Liftgate/Boot Lid Cannot be Opened


After performing this emergency measure, have the vehicle inspected at an expert repairer, we recommend an Authorised Mazda Repairer as soon as possible.

READ NEXT:

 Active Driving Display Does Not Operate

If the Active Driving Display does not operate If the active driving display does not operate, switch the ignition off and then restart the engine. If the active driving display does not operate

 Customer Information

Important consumer information including warranties and add-on equipment.

 Warranty

SEE MORE:

 Child-Restraint Precautions

Mazda strongly urges the use of child-restraint systems for children small enough to use them. Mazda recommends use of a Mazda genuine child-restraint system or one that complies with the UNECE *1 44 regulation. If you would like to purchase a Mazda genuine child-restraint system, please

 Diagnostic Assist Function [Audio]

LCD Inspection 1. Turn the ignition switch to the ACC or ON position. 2. Turn the center panel unit power to on. 3. While pressing the POWER/VOLUME switch, simultaneously press the TUNE/TRACK UP switch for 0.5 s or more. 4. Inspect according to the following table: 5. Cancel the diagnostic assi

© 2016-2023 Copyright www.ma2auto.com