Mazda 2: DTC B1129:11/B1129:12/B1129:13/B1129:19/B1129:1A
Mazda 2 2007-2014 Service Manual / Restraints / DTC / DTC B1129:11/B1129:12/B1129:13/B1129:19/B1129:1A
System Malfunction Location
Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.
- Resistance other than 1.54-5.06 ohms detected in passenger-side curtain air bag module circuit
- Wiring harness between the passenger-side curtain air bag module and SAS control module has a malfunction.
Possible Causes
- Passenger-side curtain air bag module connector malfunction
- Open or short circuit in the wiring harness between the passenger-side curtain air bag module and SAS control module
- Passenger-side curtain air bag module malfunction
- SAS control module malfunction
System Wiring Diagram
Diagnostic Procedure
DTC B1193:00
System Malfunction Location
- SAS control module operation (deployment)
Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.
- SAS control module operates (deploys) air bag module or pre-tensioner seat belts
Possible Causes
- SAS control module operation (deployment)
- SAS control module malfunction
Diagnostic Procedure
DTC C0061:29/C0062:29/C0063:29
System Malfunction Location
Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection with only detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.
- Malfunction in the SAS control module
Possible Causes
- SAS control module malfunction
Diagnostic Procedure
READ NEXT:
DTC U0028:88
System Malfunction Location
DSC HU/CM communication fault
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
DTC U0300:00/U2100:00
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
DTC U3003:16/U3003:17
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
SEE MORE:
Intake-air System
INTAKE-AIR SYSTEM LOCATION INDEX
Air cleaner
(See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION)
(SeeAIR CLEANER ELEMENT INSPECTION)
Variable tumble shutter valve actuator
(See VARIABLE TUMBLE SHUTTER VALVE ACTUATOR REMOVAL/INSTALLATION)
(SeeVARIABLE TUMBLE SHUTTER VALVE ACTUATOR INSPECTION
Fuel-Filler Flap and Cap
WARNING
When removing the fuel-fi ller cap,
loosen the cap slightly and wait for any
hissing to stop, then remove it:
Fuel spray is dangerous. Fuel can
burn skin and eyes and cause illness
if ingested. Fuel spray is released
when there is pressure in the fuel tank
and the fuel-fi ller cap is
© 2016-2023 Copyright www.ma2auto.com
