Mazda 2: Oil Control Valve (OCV)

OIL CONTROL VALVE (OCV) INSPECTION

Coil Resistance Inspection

1. Disconnect the negative battery cable.

2. Disconnect the OCV connector.

3. Measure the coil resistance between terminals A and B using a tester.

Mazda 2. OIL CONTROL VALVE (OCV)

Oil control valve (OCV) coil resistance

READ NEXT:

 Timing Chain

TIMING CHAIN REMOVAL/INSTALLATION WARNING: Do not remove the jack from the engine with the bolt of engine mount No. 3 removed because the engine may fall off and cause a serious accident. 1. Dis

 Cylinder Head Gasket

CYLINDER HEAD GASKET REPLACEMENT WARNING: Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel line spills an

 Front Oil Seal

FRONT OIL SEAL REPLACEMENT 1. Disconnect the negative battery cable. 2. Remove the drive belt. (See DRIVE BELT REMOVAL/INSTALLATION). 3. Remove in the order indicated in the table. 4. Install in th

SEE MORE:

 DriveLine & Axle

GENERAL PROCEDURES (FRONT AND REAR AXLES) Wheel and Tire Installation 1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque. Tightening Torque 88-118 N*m {9.0-12 kgf*m, 65-87 ft*lbf} Connector Disconnection 1. Disconnect t

 Intermediate Shaft

INTERMEDIATE SHAFT REMOVAL/INSTALLATION WARNING: The steering column (EPS motor) temperature increases directly after continuous turning of the steering mechanism which could cause burns if it is touched. Before performing any servicing, verify that the steering column has cooled off. CAUTI

© 2016-2023 Copyright www.ma2auto.com