Mazda 2: Engine
Mazda 2 2007-2014 Service Manual / Engine
- Foreword
- On-Board Diagnostic Test
- OBD-II Drive Mode
- DTC Table
- Symptom Diagnostic Index
- Intermittent Concern Troubleshooting
- Engine Control System Operation Inspection
- Engine System
- Engine Tune-up
- Drive Belt
- Valve Clearance
- Variable Valve Timing Actuator
- Oil Control Valve (OCV)
- Timing Chain
- Cylinder Head Gasket
- Front Oil Seal
- Rear Oil Seal
- Engine
- Lubrication System
- Cooling System
- Intake-air System
- Fuel System
- Before/After Service
- Fuel Line Pressure
- Fuel Tank
- Fuel Pump Unit
- Quick Release Connector
- Fuel Injector
- Exhaust System
- Emission System
- Fuel-filler Cap
- Charcoal Canister
- Purge Solenoid Valve
- EGR Valve
- Positive Crankcase Ventilation (PCV)
- Quick Release Connector (Emission System)
- Canister Vent (CV) Solenoid Valve
- Ignition System
- Charging System
- Starting System
- Control System
- PCM
- Neutral Switch
- Engine Coolant Temperature (ECT) Sensor
- Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor
- Manifold Absolute Pressure (MAP) Sensor
- Air Fuel Ratio (A/F) Sensor
- Heated Oxygen Sensor (HO2S)
- Crankshaft Position (CKP) Sensor
- Camshaft Position (CMP) Sensor
- Knock Sensor (KS)
- Fuel Tank Pressure Sensor
READ NEXT:
Foreword
When the customer reports a vehicle malfunction, check the malfunction
indicator lamp (MIL) indication and
diagnostic trouble code (DTC), then diagnose the malfunction according to
the followin
On-Board Diagnostic Test
DTC Reading Procedure
1. Connect the M-MDS (IDS) to the DLC-2.
2. After the vehicle is identified, select the following items from the
initialization screen of
the IDS.
Select "Self Test".
Select
OBD-II Drive Mode
Using the OBD-II Drive Mode, the monitoring item requested by OBD-II
regulations can be easily diagnosed.
Performing the Drive Mode inspects the OBD-II system for proper
operation and must be p
SEE MORE:
General Procedures
Wheel And Tire Removal/Installation
1. When installing the wheels and tires, tighten the wheel nuts in a
criss-cross pattern to the
following tightening torque.
Tightening Torque
88-118 N*m {9.0-12 kgf*m, 65-87 ft*lbf}
Suspension Links Removal/Installation
NOTE:
To prevent the bushings fro
Rear Suspension
REAR SUSPENSION LOCATION INDEX
Rear shock absorber
(See REAR SHOCK ABSORBER REMOVAL/INSTALLATION.)
(See REAR SHOCK ABSORBER INSPECTION.)
(See REAR SHOCK ABSORBER DISPOSAL.)
Rear coil spring
(See REAR COIL SPRING REMOVAL/INSTALLATION.)
Torsion beam axle
(See TORSION BEAM AXLE R
© 2016-2024 Copyright www.ma2auto.com
