Mazda 2: Towing Description
We recommend that towing be done only
by an expert repairer, we recommend
an Authorised Mazda Repairer or a
commercial tow-truck service.
Proper lifting and towing are necessary
to prevent damage to the vehicle.
Government and local laws must be
followed.
A towed vehicle usually should have its
drive wheels (front wheels) off the ground.
If excessive damage or other conditions
prevent this, use wheel dollies.

When towing with the rear wheels on the
ground, release the parking brake.
CAUTION
- Do not tow the vehicle pointed
backward with driving wheels on
the ground. This may cause internal
damage to the transaxle.

- Do not tow with sling-type
equipment. This could damage your
vehicle. Use wheel-lift or fl atbed
equipment.

If towing service is not available in an
emergency, the vehicle may be towed with
all four wheels on the ground using the
towing hook at the front of the vehicle.
Only tow the vehicle on paved surfaces for
short distances at low speeds.
CAUTION
Follow these instructions when towing
the vehicle with all wheels on the
ground.
- Shift to neutral (Manual transaxle),
or the N position (Automatic
transaxle).
- Switch the ignition to ACC.
- Release the parking brake.
Remember that power assist for the
brakes and steering will not be available
when the engine is not running.
READ NEXT:
CAUTION
The towing eyelet should be used
in an emergency (to get the vehicle
out of a ditch or a snow bank, for
example).
When using the towing eyelets,
always pull the lead or chain in
If any warning light turns on/fl ashes, take appropriate action for each
light. There is no
problem if the light turns off, however if the light does not turn off or turns
on/fl ashes again,
con
SEE MORE:
Split/One-piece Folding the
Seatback
By lowering the rear seatback(s) the
luggage compartment space can be
expanded.
WARNING
Do not drive the vehicle with occupants
on folded down seatback(s) or in the
luggage compartment.
Putting occupants in the luggage
compartment is dangerous because
HEATED OXYGEN SENSOR (HO2S) REMOVAL/INSTALLATION
WARNING:
A hot engine and exhaust system can cause severe burns. Turn off the
engine and wait
until they are cool before removing the exhaust system.
1. Disconnect the negative battery cable.
2. Remove the air cleaner cover. (See INTAKE-AIR SYS
© 2016-2023 Copyright www.ma2auto.com
