Mazda 2: DTC B0002:11/B0002:12/B0002:13/B0002:19/B0002:1A
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
inspection according to only the detection conditions may cause injury due
to an operating error, or damage
the system. When performing an inspection, always follow the inspection
procedure.
- Abnormal resistance (other than 1.76-5.06 ohms) detected in the
driver-side air bag module (inflator
No.2) circuit
- Malfunction in the wiring harness between the driver-side air bag module
(inflator No.2) and SAS control
module
Possible Causes
- Driver-side air bag module (inflator No.2) connector malfunction
- Open or short circuit or short to ground or short to power supply in the
wiring harness between the clock
spring and SAS control module
- Clock spring malfunction
- Driver-side air bag module (inflator No.2) malfunction
- SAS control module malfunction
System Wiring Diagram

Diagnostic Procedure



DTC B0002:55/B0011:55
System Malfunction Location

Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- SAS control module configuration setting has not been done correctly
Possible Causes
- SAS control module configuration setting not implemented
- SAS control module configuration setting invalid
- Driver-side air bag module or passenger-side air bag module assembly
incorrect
- SAS control module malfunction
Diagnostic Procedure

DTC B0003:53
System Malfunction Location
- Operation (deployment) inhibited due to configuration setting
Detection Condition
WARNING:
- Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause injury due to an operating error, or damage the system. When
performing an
inspection, always follow the inspection procedure.
- The SAS control module configuration has not been set and other DTCs
present
Possible Causes
- The SAS control module configuration has not been set and other DTCs
present
Diagnostic Procedure


READ NEXT:
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only th
System Malfunction Location
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an
inspection according to only th
SEE MORE:
CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION
CAUTION:
When replacing the CKP sensor, make sure there is no foreign material on
it such as
metal shavings. If it is installed with foreign material, the sensor output
signal will
malfunction resulting from fluctuation in magnetic flux a
Seat Operation
Seat Slide
To move a seat forward or backward, raise the lever and slide the seat to the
desired position
and release the lever.
Make sure the lever returns to its original position and the seat is locked in
place by
attempting to push it forward and backward.
© 2016-2023 Copyright www.ma2auto.com
