Mazda 2: Conventional Brake System
CONVENTIONAL BRAKE SYSTEM LOCATION INDEX

- Vacuum line
- (See VACUUM LINE INSPECTION.)
- (See VACUUM HOSE REMOVAL/INSTALLATION.)
- Brake fluid
- (See BRAKE FLUID INSPECTION.)
- (See BRAKE FLUID AIR BLEEDING.)
- Power brake unit
- (See POWER BRAKE UNIT INSPECTION.)
- (See POWER BRAKE UNIT REMOVAL/INSTALLATION.)
- Brake pedal
- (See BRAKE PEDAL INSPECTION.)
- (See BRAKE PEDAL REMOVAL/INSTALLATION.)
- Brake switch
- (See BRAKE SWITCH INSPECTION [MTX].)
- (See BRAKE SWITCH INSPECTION [ATX].)
- Rear brake (drum)
- (See REAR BRAKE (DRUM) INSPECTION.)
- (See REAR BRAKE (DRUM) REMOVAL/INSTALLATION.)
- (See WHEEL CYLINDER DISASSEMBLY/ASSEMBLY.)
- (See BRAKE HOSE (REAR) REMOVAL/INSTALLATION.)
- Front brake (disc)
- (See FRONT BRAKE (DISC) INSPECTION.)
- (See FRONT BRAKE (DISC) REMOVAL/INSTALLATION.)
- (See DISC PAD (FRONT) REPLACEMENT.)
- (See CALIPER (FRONT) DISASSEMBLY/ASSEMBLY.)
- (See BRAKE HOSE (FRONT) REMOVAL/INSTALLATION.)
- Master cylinder
- (See MASTER CYLINDER REMOVAL/INSTALLATION.)
- (See BRAKE FLUID LEVEL SENSOR INSPECTION.)
READ NEXT:
BRAKE FLUID INSPECTION
1. Verify that the brake fluid level in the reserve tank is between the MAX
and MIN marks.
If the brake fluid level is below the MIN mark, add brake fluid.
BRAKE FLUID AIR
BRAKE PEDAL INSPECTION
Pedal Height Inspection
1. Measure the distance from the steering shaft cover to the center of the
upper surface of
the pedal pad and verify that it is as specified.
If not
BRAKE SWITCH INSPECTION
CAUTION:
Inspect the brake switch with it installed to the brake pedal, otherwise
the brake switch
may not operate normally after inspection. If the brake switch is remove
SEE MORE:
NOTE:
If the location, time, and broadcasting station etc. can be specified
through interview with the customer, there is the possibility
that the signal reception environment is the cause of the problem.
Perform confirmation of symptom and evaluate under the conditions that
customer reporte
AUTOMATIC TRANSAXLE CONTROL SYSTEM WIRING DIAGRAM
NOTE:
Only the transaxle-related information is described.
FOREWORD
When the customer reports a vehicle malfunction, check the malfunction
indicator lamp (MIL) illuminating, O/D
OFF indicator light flashing, and diagnostic trouble code (DTC)
© 2016-2023 Copyright www.ma2auto.com
