Mazda 2: Body and Accessories
Mazda 2 2007-2014 Service Manual / Body and Accessories
- Foreword [Immobilizer System (Keyless Entry System) ]
- DTC Table [Immobilizer System (Keyless Entry System) ]
- Foreword [Multiplex Communication System]
- Determining Malfunctioning Part (HS-CAN) [Multiplex Communication System]
- M-MDS and Vehicle Not Communicating [Multiplex Communication System]
- ON-Board Diagnostic Wiring Diagram [Instrument Cluster]
- DTC Table [Instrument Cluster]
- ON-Board Diagnostic Wiring Diagram [BCM]
- DTC Table [BCM]
- DTC Inspection [Audio]
- DTC Table [Audio]
- Diagnostic Assist Function [Audio]
- Power Window System Wiring Diagram [Power Window System]
- Keyless Entry System Wiring Diagram [Keyless Entry System]
- Symptom Troubleshooting [Instrument Cluster]
- Foreword [Audio]
- Foreword [Radio]
- Reference [Radio]
- Foreword [CD Player]
- Reference [CD Player]
- Body Panels
- Door and Liftgate
- Glass/Windows/Mirrors
- Seat
- Security and Locks
- Front Outer Handle
- Rear Outer Handle
- Door Lock Switch
- Fuel-filler Lid Opener Cable
- Front Door Key Cylinder
- Front Door Latch and Lock Actuator
- Front Door Latch Switch
- Rear Door Latch and Lock Actuator
- Liftgate Latch and Lock Actuator
- Keyless Receiver
- Coil Antenna
- Exterior Trim
- Interior Trim
- Lighting Systems
- Wiper/Washer System
- Entertainment Location
- Power System
- Instrumentation/Driver Info.
- Control System
READ NEXT:
Foreword [Immobilizer System (Keyless Entry System) ]
DTCs are recorded in the PCM and instrument cluster when a malfunction
is detected.
The stored DTCs can be verified using the flashing pattern of the security
light and M-MDS.
There are some
DTC Table [Immobilizer System (Keyless Entry System) ]
NOTE:
The security light flashes or illuminates under the following conditions
when the ignition
is switched to off or ACC.
There is a malfunction:
DTC 16 or below: Flashes for approx. 1 min
Foreword [Multiplex Communication System]
If the CAN system is considered to be the cause of the malfunction based
on the repair order form and
the malfunctioning symptom, follow the Troubleshooting Procedure.
DTCs are also output due t
SEE MORE:
Refrigerant Pressure Switch
REFRIGERANT PRESSURE SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Collect the refrigerant. (See REFRIGERANT CHARGING).
3. Remove the ground from the engine mount No.3.
4. Remove the air cleaner installation bolt and slide the air cleaner
component aside.
5. Disconnec
Ignition System
IGNITION SYSTEM LOCATION INDEX
Ignition coil
(See IGNITION COIL REMOVAL/INSTALLATION)
(See IGNITION COIL INSPECTION)
Spark plug
(See SPARK PLUG REMOVAL/INSTALLATION)
(See SPARK PLUG INSPECTION)
IGNITION COIL REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
CAUTION:
© 2016-2023 Copyright www.ma2auto.com
